Recent content by RainMotorsports

Pretty common complaint. Many older hotends are only good around 100-120mm/s at .4 width/.2 height. Klipper helps a lot with 8 bit boards but most of these printers weren't really going to go any faster stock. Do you have any pictures of the issue occuring? Can't promise I can help. I was...

I apologize for not responding to this sooner. Haven't really gotten back around to working on the site. I have no real limit to whats old enough or isn't. Eventually they will all be there right? I assume you don't currently need any help with it? If you have a config for a stock printer you...

Article Placeholder [mcu] serial: /dev/ttyACM0 restart_method: arduino #Settings matched closest to original firmware. Increase as desired. [printer] kinematics: cartesian max_velocity: 200 max_accel: 1000 max_z_velocity: 30 max_z_accel: 25 [stepper_x] step_pin: PC0 dir_pin: PL1 enable_pin...

This article and the configuration i submitted to Marlin are written against the last model of M2, the Revision H. We will discuss the differences in other revisions to assist you in getting your specific revision work as well. But I am unable to test them myself. Some of the original firmware...

Article Placeholder Sources/Credits There are a couple of potential starting points for a replicator config. The Flash Forge Creator Pro has certainly received more attention and is almost the same printer. Sgail7 has tried to give the entire early replicator family support in klipper. However...

We actually wrote the example configurations for the original Makerbot Replicator so this guide will be more or less the same. Note that the original submission has an incorrect hotend offset (Y instead of X) and that is fixed in this article and hopefully in the example soon. Table of Contents...

Article Placeholder

Article Placeholder Table of Contents Flashing Configuration.h Configuration_adv.h Configuration.h Define the main board: #define MOTHERBOARD BOARD_ULTIMAIN_2 The example config has this enabled: #define BAUD_RATE_GCODE Not always a critical item, but we define the filament diameter here...

Article In Progress Printer Notes This config will be for a stock UMO with a 1.5.7 board, UltiController and a 12×3 Leadscrew. If your printer differs from this please take some of the following into account. Print Area Advertised as 210x210x205 the Marlin config is 205 cubed. XY might reach...

ARTICLE IN PROGRESS Introduction We will be covering the Ultimaker Original with the 1.5.7 board, UltiController, MXL Belts/Pullies, 12mm leadscrew set to 1/8 microstepping as was stock and available late 2012 and onwards. I will go through all of the changes to a blank 2.1.3 config file to...

Article 10

Article in Progress Some boards are a pain to flash. They might not have a reset capacitor or a bootloader. Arduino based boards can be programmed directly over the ICSP header using something like Tiny ASP, USB ASP, or something like an Arduino UNO which is the option I will cover today. It is...

Article 8

Article 5

Article in Progress So you have chosen Klipper (or Kalico)! Installation is easy, getting it running can vary. While you have other choices, the Raspberry Pi is the most widely supported device. We will be covering 2 very common choices. In this article we will cover installing MainsailOS using...