Anycubic Chiron

[Maximus1]

Hi,
I still have an Anycubic Chiron here, which is still almost in its original condition. It runs Klipper on it.
Is he already old enough to be an "old3dprinter"?

 

[RainMotorsports]

Hi,
I still have an Anycubic Chiron here, which is still almost in its original condition. It runs Klipper on it.
Is he already old enough to be an "old3dprinter"?

I apologize for not responding to this sooner. Haven't really gotten back around to working on the site.

I have no real limit to whats old enough or isn't. Eventually they will all be there right? I assume you don't currently need any help with it? If you have a config for a stock printer you can submit it to Klipper to help others. You are welcome to share it here as well. But please note if you have any major changes. I always try to submit stock configs and walk through any changes oitherwise.

 

[Maximus1]

Thanks for the answer.
I actually only have the problem that it is too slow and I need a faster hotend.
Oh yes, and from about 1cm height the print becomes unclean.

 

[RainMotorsports]

Thanks for the answer.
I actually only have the problem that it is too slow and I need a faster hotend.
Oh yes, and from about 1cm height the print becomes unclean.

Pretty common complaint. Many older hotends are only good around 100-120mm/s at .4 width/.2 height. Klipper helps a lot with 8 bit boards but most of these printers weren't really going to go any faster stock.

Do you have any pictures of the issue occuring? Can't promise I can help. I was dealing with some issues last night for example and would have only solved it being there.

 

[Maximus1]

I only print 80-100mm/s with it, but it makes messes especially with silk pla.