Featured content

3D Printopia was our intended launch. But if you look around nothing is done! The primary reason behind this is the collection grew what felt like nearly a printer a week over these past few months. I tended to each machine as it came in putting the rest of the project a few months behind. We have a lot to do as it is more than just providing configurations for Marlin or Klipper. Guides for setting up your VScode environment for Marlin, Installing Klipper, flashing specific boards, and...

During 3D Printopia it became a bit clear those with only my makerchip might not have good ways to contact me and with the project a few months behind these early contacts are important! So here is our discord, all of our socials, and ways to get ahold of me. Discord Invite Link - https://discord.com/invite/zkfVahfmRJ Permanent Redirect - https://discord.thisold3dprinter.com